Program an OSSM Gold Motor using Web Serial and Modbus RTU.
Configure or restore the OSSM defaults on a Gold Motor (57AIM series) directly from a supported desktop browser.
This is a motor programmer, not a firmware flasher
This tool reads and writes motor configuration registers over Modbus RTU. It does not download firmware and therefore does not use the Supabase firmware-manifest pathway.
Disconnect the OSSM signal cable first
Remove the OSSM Reference Board four-pin signal plug before programming. Power the motor with 20–36 V DC and connect it through an RS485 USB adapter. Use Chrome or Edge on a desktop computer.
Gold Motor Control
Connection Instructions:
Connect the motor using an RS485 USB adapter that provides 5V+, GND, A, B. Example
The motor must have 20-36V DC supplied, which can come from the OSSM Reference Board or external power source.
Important: The OSSM Reference Board 4-Pin Signal Plug must be disconnected while programming.
v2.0 alpha